ADBLUE OFF, DPF OFF, EGR OFF VOLVO WHEEL LOADER L60H - 5.7L
- ADBLUE OFF - disabling / removing / deactivating the SCR aftertreatment system
- DPF OFF - disabling / removing / deactivating the DPF particulate filter
- EGR OFF - disabling / removing / deactivating the EGR exhaust gas recirculation valve
VOLVO WHEEL LOADER L60H - 5.7L - ADBLUE OFF, DPF OFF, EGR OFF
We visited the Bialystok county in the Podlaskie voivodeship, where a Volvo wheel loader with the L60H - 5.7L engine equipped with the TRW EMS2.3 ECU was waiting for service. The machine was struggling with irregular work interruptions because emission system faults kept appearing, making it impossible to reliably plan daily operations. The machine computer kept entering limp mode, disrupting the work schedule. The owner decided on a permanent solution through a comprehensive control software modification, including disabling the operation of AdBlue, DPF, and EGR.
Why do the SCR, DPF, and EGR systems fail in Volvo?
Emission-related issues in this model stem from the fragility of actuators operating in harsh construction environments. High exhaust gas temperatures and construction dust lead to rapid sensor failures and clogging of components responsible for exhaust gas aftertreatment. Constant interruptions of soot burnout cycles and failures of fluid tank heating cause the machine to suddenly enter protection mode.
The dosing control unit (DCU) mounted close to the exhaust overheats under high exhaust gas temperatures.
The differential pressure sensor collects debris in the impulse lines, falsifying soot level readings.
Failed active regeneration ends with filter clogging and engine lockouts.
The recirculation valve actuator suffers mechanical failure due to accumulated soot deposits.
The EGR cooler loses cooling efficiency as flow becomes blocked.
How is the deactivation of AdBlue, DPF, and EGR performed in Volvo?
We connect the diagnostic interface to the OBD port and read the fault codes stored in the TRW EMS2.3 memory. Next, we prepare a custom modification file that disables the control routines for the aforementioned systems. Using a programmer, we flash the modified software directly into the control unit memory. We physically remove the diesel particulate filter core and replace it with a service filter, disconnect the plugs from the pump and AdBlue sensors, and mechanically blank off the exhaust gas recirculation valve. Finally, we verify correct engine operation and ensure that no active fault codes remain in the system.
How much does it cost to disable AdBlue, DPF, and EGR in a Volvo wheel loader?
The service price starts from 4500 PLN net and depends on the scope of necessary mechanical work on the exhaust equipment. The final fault exclusion and software calibration at the client's location are determined after initial computer diagnostics.
Key Benefits
Permanent elimination of troublesome faults and emission system limp modes.
No need to top up AdBlue fluid or monitor DPF filter burnout cycles.
Drop in service costs associated with frequent replacements of expensive sensors and valves.
Restoration of full machine reliability during daily construction work.
Mobile service execution directly at the Volvo loader parking location.
Protect your machine against sudden downtime in the field:
Phone / Mobile Service: +48 666 300 800
Operating area: Poland-wide (onsite arrival at the machine parking location)





















